BearerSize

Barcode.BearerSize    specifies the thickness of the bearer bar(s)

Default value 0          This variable is used to set the thickness of bearer bars in HIMETRIC units.

If the bearer thickness is a non-zero value then a bearer bar is produced above and below the bars IF the DL_FLAG_BEARERS flag is set (see Flags), or only above the bars if the DL_FLAG_BEARERS flag is not set. To have no bearer bars the bearer thickness must be 0.

The light margin value is applied whether or not bearer bars are produced.

Note that if bearer bars have been specified and the DL_FLAG_EXBEARERS flag has been set, then the bearer bars extend over the light margins. If the DL_FLAG_EXBEARERS flag has not been set then the bearers do not extend into the light margins.

This parameter is ignored for for ITF and ITF-6 barcodes, which have their own standards for these items.

 

More:

BorderThickness