Xunit

Barcode.Xunit the thickness of the thinnest bar in the barcode in Mils (thousandths of an inch).

Default value: 0 (the Xunit value is not used when set = 0)

Allowed values: 10 – 300 mils

This may be used to specify the X unit dimension (ie. The width of the narrowest bar) in standard mil units (NOT mm. 1 mil = 0.001 inches). Barcode should not normally be produced with an X value smaller than 10, and MUST NOT be produced with an X value smaller than 8 - or the barcode will not meet the standard specification. This provides an alternative way of specifying the barcode size - rather than using the ImageWidth parameter. When Xunit is specified the length of the barcode is calculated within the component and the length implied by other parameters is ignored.